P0A7A-522

HYBRID / BATTERY CONTROL: HYBRID CONTROL SYSTEM: P0A7A-522: Generator Inverter Performance
P0A7A-522 - Generator Inverter Performance

DESCRIPTION

For a description of the inverter, P0A78-266.

If the inverter receives a generator gate shutdown signal from the MG ECU, it will turn all power transistors off which are activating MG1 to forcibly stop MG1 operation.

The MG ECU monitors generator gate shutdown signals and detects a malfunction.





HINT
- If DTC P0A7A-522 is output, the hybrid system cannot be restarted until the DTC is cleared.
- If the malfunction is not reproduced, leave the vehicle for 1 minute with neutral (N) selected in order to easily reproduce the malfunction.

MONITOR DESCRIPTION

The MG ECU monitors the current to the MG1. The MG ECU checks if current passes to the MG1 while the vehicle is stopped with the power switch on (IG) or neutral (N) selected. If current flow is detected in either of these two situations, the hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE





CONFIRMATION DRIVING PATTERN

1. Connect the Techstream to the DLC3.

2. Turn the power switch on (IG) and turn the Techstream on.

3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4. Turn the power switch off.

5. Turn the power switch on (READY) and turn the Techstream on.

6. With the vehicle stopped and park (P) selected, move the shift lever to N, wait for 10 seconds and then push the P position switch.

NOTICE:
Do not leave the vehicle for an extended time with the shift lever in N.

7. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

8. Check that permanent DTCs are cleared.

9. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

HINT
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

CAUTION:
- Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
- After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.
HINT
Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

PROCEDURE

1. CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR) P0343

NG -- CONNECT SECURELY

OK -- REPLACE INVERTER WITH CONVERTER ASSEMBLY Components