Installation

4GR-FSE FUEL: FUEL PRESSURE SENSOR: INSTALLATION

1. INSTALL FUEL PRESSURE SENSOR

(a) Install a new gasket to the fuel pressure sensor.

(b) Using SST, install the fuel pressure sensor to the No. 1 delivery pipe.





SST : 09922-10010

without SST - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

with SST - Torque : 32 Nm (324 kgf-cm, 23 ft-lbf)

HINT
* The torque for use with SST is the torque when SST is used at the position shown in the illustration.
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.

(c) Connect the connector with the clamp.





2. INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY Installation

3. CONNECT WATER HOSE JOINT Installation

4. INSTALL INTAKE MANIFOLD

HINT
Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. INSPECT FOR FUEL LEAK Fuel System