Operation CHARM: Car repair manuals for everyone.

B1207





NETWORKING: MULTIPLEX COMMUNICATION SYSTEM: B1207: Smart ECU Stop
B1207 - Smart ECU Stop

DESCRIPTION

* This DTC is detected if communication between the certification ECU (smart key ECU assembly) and gateway ECU stops for more than 10 seconds.





WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
If "B or GND short malfunction of communication bus" DTCs (B1214 and B1215) are detected at the same time as "communication stop" DTC B1207, perform troubleshooting for the "+B or GND short malfunction of communication bus" DTCs first B1214.

PROCEDURE

1. INSPECT FUSE (SECURITY)

(a) Remove the SECURITY fuse from the main body ECU LH (cowl side junction block LH).

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE FUSE (SECURITY)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND)

(a) Disconnect the P33 connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (COMMUNICATION LINE)

(a) Disconnect the P33, RJ and M18 connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal