Operation CHARM: Car repair manuals for everyone.

B1280





NETWORKING: MULTIPLEX COMMUNICATION SYSTEM: B1280: Left Side Junction Block ECU Communication Stop
B1280 - Left Side Junction Block ECU Communication Stop

DESCRIPTION

This DTC is detected if communication between the main body ECU LH (cowl side junction block LH) and gateway ECU stops for more than 10 seconds.





WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
If "+B or GND short malfunction of communication bus" DTCs (B1214 and B1215) are detected at the same time as "communication stop" DTC B1280, perform troubleshooting for the "+B or GND short malfunction of communication bus" DTCs first B1214.

PROCEDURE

1. INSPECT FUSE (MPX-B)

(a) Remove the MPX-B fuse from the engine room relay block No. 1.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE FUSE (MPX-B)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (COWL SIDE JUNCTION BLOCK LH - BATTERY AND BODY GROUND)

(a) Disconnect the LD connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (COWL SIDE JUNCTION BLOCK LH - BATTERY AND BODY GROUND)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (COMMUNICATION LINE)

(a) Disconnect the Q3, A30, M18 and 2F connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MAIN BODY ECU LH (COWL SIDE JUNCTION BLOCK LH)