Operation CHARM: Car repair manuals for everyone.

Installation





2UR-GSE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

(a) Using SST, Install the heated oxygen sensor to the front exhaust pipe assembly.





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

(b) Install the grommet to the vehicle.

(c) Connect the heated oxygen sensor connector.





(d) Install the front floor silencer pad LH.

2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

(a) Using SST, Install the heated oxygen sensor to the front exhaust pipe assembly.





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

(b) Install the grommet to the vehicle.

(c) Connect the heated oxygen sensor connector.





(d) Install the front floor silencer pad RH.

3. INSTALL FRONT FLOOR FOOTREST LH Installation

4. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

5. INSTALL FRONT DOOR SCUFF PLATE LH Installation

6. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation

7. INSTALL FRONT DOOR SCUFF PLATE RH Installation