Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2012 >> IS F V8-5.0L (2UR-GSE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Front Airbag Sensor >> Installation

Installation





SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION

1. INSTALL FRONT AIRBAG SENSOR

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Temporarily install the front airbag sensor with the 2 claws and pin.





(d) Install the front airbag sensor with the 2 bolts.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* Make sure that the pin is securely inserted into the body hole.
* Tighten the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.

(e) Connect the connector to the front airbag sensor.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(f) Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY Installation

3. INSTALL FRONT UPPER FENDER PROTECTOR LH (for LH Side) Installation

4. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side) Installation

5. INSTALL FRONT UPPER FENDER PROTECTOR RH (for RH Side) Installation

6. INSTALL ENGINE ROOM SIDE COVER RH (for RH Side) Installation

7. INSTALL FRONT BUMPER ASSEMBLY Installation

8. INSTALL RADIATOR GRILLE PROTECTOR Installation

9. INSTALL COOL AIR INTAKE DUCT SEAL Installation

10. ADD WASHER FLUID (w/ Headlight Cleaner System) Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. ADJUST HEADLIGHT AIMING

(a) Adjust headlight aiming Adjustments.

13. ADJUST FOG LIGHT AIMING

(a) Adjust fog light aiming Adjustments.

14. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.
pro multis · About Operation CHARM