Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: REMOVAL
HINT
* Use the same procedure for the RH side and LH side.
* The following procedure is for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE FRONT DOOR SCUFF PLATE Removal
4. REMOVE REAR DOOR SCUFF PLATE Removal
5. REMOVE LOWER CENTER PILLAR GARNISH Removal
6. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.
HINT
Tape the screwdriver tip before use.
(d) Disconnect the connectors.
(e) Remove the 2 bolts and separate the front seat outer belt assembly.
7. REMOVE FRONT SEAT BELT RETRACTOR COVER
(a) Disengage the claw and remove the front seat belt retractor cover from the body.
8. REMOVE SIDE AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the side airbag sensor.
NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(d) Remove the nut and disengage the pin, and remove the side airbag sensor.
NOTICE:
Loosen the nut while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.