Removal

L110F HYBRID VEHICLE CONTROL: FRAME WIRE: REMOVAL

1. REMOVE SERVICE PLUG GRIP

(a) Remove the service plug grip Removal.

2. REMOVE REAR SEAT ASSEMBLY (for Power Seat)

(a) Remove the rear seat assembly Removal.

3. REMOVE REAR SEAT ASSEMBLY (for Ottoman)

(a) Remove the rear seat assembly Removal.

4. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

(a) Remove the rear seat assembly Removal.

5. REMOVE ENGINE ASSEMBLY WITH TRANSMISSION

(a) Remove the engine assembly with transmission Removal.

6. REMOVE FUEL TANK ASSEMBLY

(a) Remove the fuel tank assembly Removal.

7. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

(a) Remove the rear suspension member sub-assembly Removal.

8. REMOVE NO. 1 COOLER COVER (w/ Rear Air Conditioning System) Removal

9. REMOVE ROPE HOOK Removal

10. REMOVE ROPE HOOK ASSEMBLY Removal

11. REMOVE DECK TRIM SIDE BOARD RH Removal

12. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Removal

13. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER Removal

14. REMOVE REAR FLOOR FINISH PLATE Removal

15. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Removal

16. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH Removal

17. REMOVE NO. 1 CENTER FLOOR TO BRACE EXTENSION Removal

18. REMOVE NO. 2 HV BATTERY SHIELD SUB-ASSEMBLY Removal

19. REMOVE SPARE WHEEL GUARD SUB-ASSEMBLY Removal

20. SEPARATE HV BATTERY

CAUTION:
Wear insulated gloves.

(a) Remove the 2 nuts and disconnect the frame wire from the HV battery.

NOTICE:
Insulate the terminals of the removed high voltage wire with insulating tape.

(b) Remove the battery shield contact from the HV battery.

(d) Disconnect the connector and detach the 3 clamps.

(e) Detach the claw, remove the 2 nuts and separate the frame wire from the luggage terminal.

21. SEPARATE INVERTER WITH CONVERTER ASSEMBLY

CAUTION:
Wear insulating gloves.

(a) Remove the bolt and separate the frame wire from the inverter with converter assembly.

NOTICE:
Cover the hole where the cable was connected with tape or equivalent (non-residue type) to prevent entry of foreign matter.

22. REMOVE WIRE HARNESS PROTECTOR

(a) Remove the 4 nuts, 2 clamps and wire harness protector.

(b) Remove the 3 nuts, clip and wire harness protector.

HINT
When removing the clip, break the claw on the clip. This clip cannot be reused.

23. REMOVE FRAME WIRE

(a) Remove the 2 nuts from the frame wire.

(b) Release the 2 claws and disconnect the frame wire from the engine room No. 1 junction block.

(c) Remove the 2 bolts and clamp.

(d) Remove the 3 nuts and bolt.

(e) Remove the 4 nuts and bolt.

(f) Remove the 3 nuts and 2 bolts.

(g) Remove the grommet and pull out the frame wire from the cabin.

(h) Remove the 2 bolts and pull out the frame wire from the cabin.

(i) Remove the 5 clips and frame wire from the vehicle.

HINT
When removing the clips, break the claws on the clips. These clips cannot be reused.