Removal
HYBRID BATTERY CONTROL: SERVICE PLUG GRIP: REMOVAL
1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal
3. REMOVE BATTERY SERVICE HOLE COVER LH Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
* w/ Navigation System (for HDD):
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
5. REMOVE REAR LOWER SEAT CONSOLE BOX COVER (for 4-Passenger with Ottoman) Removal
6. REMOVE ARMREST DOOR CAP (except 4-Passenger with Ottoman)
(a) Using a thin-bladed screwdriver, detach the 6 claws.
HINT
Tape the screwdriver tip before use.
(b) Detach the 2 hooks and remove the armrest door cap.
7. REMOVE SERVICE PLUG COVER
(a) Remove the 4 bolts and service plug cover.
8. REMOVE SERVICE PLUG GRIP
CAUTION:
* Remove the service plug grip to interrupt a high voltage circuit at the time of the check.
* Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
* All the high voltage wiring connectors are orange colored.
(a) Wear insulated gloves. Slide the service plug grip upward, turn the lever downward, and then remove the service plug grip.
CAUTION:
After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.
NOTICE:
Never turn the power switch on (READY) with the service plug grip removed as malfunctions may occur.
HINT
Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.