Installation

2UR-FSE FUEL: INJECTOR DRIVER: INSTALLATION

NOTICE:
While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/ close the doors while the battery is connected.

1. INSTALL INJECTOR DRIVER

NOTICE:
* Be careful not to drop or strike the injector driver.
* The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.

(a) Install the 2 injector drivers to the bracket with the 8 nuts.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

(b) Temporarily install the 2 injector drivers (with bracket) with the 2 bolts and 2 nuts.

(c) Tighten the 2 bolts and 2 nuts in the order shown in the illustration.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)





(d) Connect the 8 injector driver connectors.





(1) Connect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks to the 2 injector drivers.

NOTICE:
Connect the connector securely.

HINT
Move the lock lever in the direction indicated by the arrow to lock the connector.

2. CONNECT ENGINE WIRE HARNESS Installation

3. CONNECT ECM CONNECTOR Installation

4. CONNECT NO. 2 CONNECTOR HOLDER Installation

5. CONNECT HYBRID VEHICLE CONTROL ECU Installation

6. INSTALL OUTLET ENGINE ROOM ECM DUCT Installation

7. INSTALL ENGINE ROOM ECU COVER Installation

8. INSTALL NO. 6 COVER SUB-ASSEMBLY Installation

9. INSTALL ENGINE COVER SUB-ASSEMBLY LH Installation

10. INSTALL SKID CONTROL ECU BRACKET Installation

11. CONNECT BRAKE FLUID RESERVOIR Installation

12. CONNECT NO. 3 ENGINE ROOM RELAY BLOCK Installation

13. INSTALL SKID CONTROL ECU Installation

14. CONNECT NO. 1 MOTOR COOLING PIPE Installation

15. INSTALL AIR CLEANER ASSEMBLY LH Installation

16. INSTALL AIR CLEANER ASSEMBLY RH Installation

17. INSTALL INTAKE AIR CONNECTOR PIPE Installation

18. INSTALL SERVICE PLUG GRIP

(a) Install the service plug grip Installation.

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

20. INSTALL BATTERY SERVICE HOLE COVER LH Installation

21. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

22. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

23. INSTALL NO. 1 AIR CLEANER INLET Installation

24. INSTALL ENGINE ROOM SIDE COVER LH Installation

25. INSTALL ENGINE ROOM SIDE COVER RH Installation

26. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation

27. INSTALL V-BANK COVER SUB-ASSEMBLY Installation