Removal

LIGHTING: HAZARD WARNING SWITCH: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal

3. REMOVE BATTERY SERVICE HOLE COVER LH Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

8. REMOVE NO. 3 BOX PANEL Removal

9. REMOVE REAR CONSOLE PANEL UPPER Removal

10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

11. REMOVE RADIO RECEIVER ASSEMBLY Removal

12. REMOVE MULTI-DISPLAY ASSEMBLY Removal

13. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY (for HDD) Removal

14. REMOVE HAZARD WARNING SWITCH

(a) Disconnect the connector.





(b) Detach the 2 claws and remove the hazard warning switch.