Convertible Top Control Module: Testing and Inspection

POWER RETRACTABLE HARDTOP CONTROL MODULE INSPECTION

1. Remove the following parts:
a. Console Console Removal/Installation

b. Quarter trim Quarter Trim Removal/Installation

c. Scuff plate Scuff Plate Removal/Installation

d. Tire house trim Tire House Trim Removal/Installation

e. Aeroboard Service and Repair

f. Front seat back bar garnish Seat Back Bar Garnish Removal/Installation

g. Back trim Back Trim Removal/Installation

2. Attach the tester lead to the power retractable hardtop control module wiring harness-side connector and inspect voltage, continuity, or resistance according to the standard (reference) on the table.

Standard (Reference)





















*1
The voltage increases during operation speed control of the roof and deck panel.

Inspection using an oscilloscope (reference)

Roof motor hall sensor
- Terminal connected: power retractable hardtop control module 1I (RH), 1M (LH)-Negative battery terminal





- Oscilloscope setting: 2 V/DIV (Y): 5 ms/DIV (X), DC range
- Measurement condition: When the roof is moving.
NOTE:
1 Pulse interval varies with the roof panel operation speed.

Deck panel motor hall sensor
1 Terminal connected: power retractable hardtop control module 1K (RH), 1O (LH)-Negative battery terminal





2 Oscilloscope setting: 2 V/DIV (Y): 5 ms/DIV (X), DC range
3 Measurement condition: When the deck panel is moving.
NOTE:
1 Pulse interval varies with the deck panel operation speed.