Cruise Control Switch: Testing and Inspection

CRUISE CONTROL SWITCH INSPECTION [L3 WITH TC]

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable and wait for 1 min or more.

3. Remove the driver-side air bag module. Two-Step Deployment Control System Standard Deployment Control System

4. Disconnect the clock spring connector (part wiring harness-side).

5. Inspect for resistance and continuity between clock spring terminals K and M (part wiring harness-side) using a tester.

- If not as specified, replace the steering switch. Service and Repair









6. Apply battery positive voltage to clock spring connector terminal O (part wiring harness-side), and terminal E (part wiring harness-side) to ground.






7. Verify that the LED illuminates.

- If the LED does not illuminate, replace the steering switch. Service and Repair