Hazard Warning Switch: Service and Repair

HAZARD WARNING SWITCH REMOVAL/INSTALLATION

CAUTION:
- The hazard switch is not reuseable since it is broken when disconnected from the hazard switch knob. Do not remove the hazard switch except when replacing it.

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Shift lever knob (MT) Transmission Removal/Installation

b. Shift knob (AT) Selector Lever Removal/Installation

c. Console panel Removal and Replacement

d. Ashtray panel Removal and Replacement

e. Lower panel Lower Panel Removal/Installation

f. Knee bolster Knee Bolster Removal/Installation

g. Center panel unit Center Panel Unit Removal/Installation

h. Speaker grille Speaker Grille Removal/Installation

i. Center panel Center Panel Removal/Installation

3. Remove the screw.






4. Remove the hazard switch knob.

5. Remove the hazard switch.

6. Install in the reverse order of removal.