Hazard Warning Switch: Testing and Inspection

HAZARD WARNING SWITCH INSPECTION

CAUTION:
- The hazard switch is not reuseable since it is broken when disconnected from the hazard switch knob. Do not remove the hazard switch except when replacing it.

1. Remove the following parts:
a. Shift lever knob (MT) Transmission Removal/Installation

b. Shift knob (AT) Selector Lever Removal/Installation

c. Console panel Removal and Replacement

d. Ashtray panel Removal and Replacement

e. Lower panel Lower Panel Removal/Installation

f. Knee bolster Knee Bolster Removal/Installation

g. Center panel unit Center Panel Unit Removal/Installation

h. Speaker grille Speaker Grille Removal/Installation

i. Center panel Center Panel Removal/Installation

2. Verify that the continuity between the hazard switch terminals is as indicated in the table.






- If not as indicated in the table, replace the center panel.