Radio, Stereo, and Compact Disc: Application and ID

SUPPLIER IDENTIFICATION PROCEDURE [AUDIO]

NOTE:
- When asking the supplier (service center) for repair or replacement, identify the supplier and fill in the Audio Repair Order Form using the following procedures.

Identification Using Label or Inscribed Lettering

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front scuff plate Front Scuff Plate Removal/Installation

b. Front side trim Front Side Trim Removal/Installation

c. Console panel Rear Console Removal/Installation

d. Rear console Rear Console Removal/Installation

e. Side wall Side Wall Removal/Installation

f. Shift lever knob (MTX) Service and Repair

g. Front console component Front Console Component Removal/Installation

h. Glove compartment Service and Repair

i. Lower panel Lower Panel Removal/Installation

j. Center panel unit Center Panel Unit Removal/Installation

3. Verify the supplier indicated on the label attached on each unit.






Verify Using the Diagnostic Assist Function

1. Switch the ignition to ACC or ON.

2. Turn the audio unit power to on.

3. While pressing the POWER/VOLUME switch, simultaneously press the Preset 5 switch for 3 s or more.






4. Identify the supplier code by referring to the LCD.










NOTE:
- The supplier code can also be identified from the DTC displays screen.






5. To stop the diagnostic assist function, ignition is switched to off or turning off the audio unit power.