Carpet: Service and Repair

FLOOR COVERING REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front seat Removal and Replacement

b. Rear seat cushion Rear Seat Cushion Removal/Installation

c. Front scuff plate Front Scuff Plate Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

e. Front side trim Front Side Trim Removal/Installation

f. Rear console Rear Console Removal/Installation

g. Shift lever knob (MTX) Service and Repair

h. Side wall Side Wall Removal/Installation

i. Front console component Front Console Component Removal/Installation

j. Steering shaft cover Service and Repair

k. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

l. Lower anchor installation bolts on the front seat belt Front Seat Belt Removal/Installation

3. Remove the nuts, then remove the rear console bracket in the direction of the arrow shown in the figure.






4. Cut the floor covering at the position indicated by the arrow (1) in the figure using scissors, detach the fasteners, then remove the floor covering in the direction of the arrow (2).






NOTE:
- The cut part does not need to match up when installing the floor covering.

5. Take the floor covering out from the opened liftgate.

6. Install in the reverse order of removal.