Rear Door Lock Actuator Inspection

REAR DOOR LOCK ACTUATOR INSPECTION

1. To access the glass installation bolt, position the rear door glass so that the distance from the top of the rear door glass to the upper part of the rear beltline molding is approx. 210 mm {8.27 in}.






2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Sail inner garnish Sail Inner Garnish Removal/Installation

b. Rear door garnish

c. Rear door trim Rear Door Trim Removal/Installation

d. Rear door speaker Rear Door Speaker Removal/Installation

e. Rear door glass Service and Repair

f. Rear door module panel Rear Door Module Panel Removal/Installation

g. Rear door latch and lock actuator Service and Repair

4. Apply battery positive voltage and connect the ground to each terminal, and then verify the operation.






- If not as indicated in the table, replace the front door latch and lock actuator.