Engine Disassembly/Assembly
ENGINE DISASSEMBLY/ASSEMBLY [MZR 1.5]
1. Remove the fuel line bracket.
2. Using the bolts part number 99794 1025 or M10x1.25, length 25 mm {0.99 in} to install the SST to the position shown in the figure, hang the engine and transaxle, and then take it down from the engine jack.
Tightening torque
- 38-51 Nm {3.9-5.2 kgf-m, 29-37 ft-lbf}
3. Remove the joint shaft. Joint Shaft Removal/Installation
4. Remove the engine from the transaxle. (See Automatic Transaxle Removal/Installation (ATX).) (See Manual Transaxle Removal/Installation (MTX).)
5. Remove the EGR pipe and EGR valve. Service and Repair Service and Repair
6. Remove the intake-air system. Service and Repair
7. Remove the exhaust system. Service and Repair
8. Remove the ignition coils. Service and Repair
9. Remove the crankshaft position (CKP) sensor. Service and Repair
10. Install in the reverse order of removal.