Hazard Warning Switch: Testing and Inspection

HAZARD WARNING SWITCH INSPECTION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front scuff plate Front Scuff Plate Removal/Installation

b. Front side trim Front Side Trim Removal/Installation

c. Rear console Rear Console Removal/Installation

d. Side wall Side Wall Removal/Installation

e. Shift lever knob (MTX) Service and Repair

f. Front console component Front Console Component Removal/Installation

g. Glove compartment Service and Repair

h. Lower panel Lower Panel Removal/Installation

i. Center panel unit Center Panel Unit Removal/Installation

j. Hazard warning switch Service and Repair

3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table.






- If not as indicated in the table, replace the hazard warning switch.