Advanced Keyless Entry And Push Button Start System

KEYLESS RECEIVER INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]

1. Remove the following parts:
a. Front scuff plate (LH) Front Scuff Plate Removal/Installation

b. Front side trim (LH) Front Side Trim Removal/Installation

c. Upper panel Upper Panel Removal/Installation

d. Shift knob (MTX) Manual Transaxle Shift Mechanism Removal/Installation [G35M-R] Manual Transaxle Shift Mechanism Removal/Installation [G66M-R]

e. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation

f. Shift panel Shift Panel Removal/Installation

g. Side wall Side Wall Removal/Installation

h. Console Console Removal/Installation

2. Set the hood release lever out of the way. Service and Repair

3. Remove the lower panel. (driver-side) Lower Panel Removal/Installation

4. Measure the voltage according to the terminal voltage table.

- If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item (s)".

- If the system does not work normally even though the parts or related wiring harnesses do not have any malfunction, replace the keyless receiver.

5. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement

Terminal Voltage Table (Reference)