Antenna Amplifier: Service and Repair

ANTENNA AMPLIFIER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

2. Remove the rain sensor cover. (Vehicles with auto light/wiper system) Service and Repair

3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)

4. Partially peel back the seaming welts.

5. Remove the following parts:
a. Sunroof seaming welt (vehicles with sunroof)

b. A-pillar trim A-Pillar Trim Removal/Installation

c. Front scuff plate Front Scuff Plate Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

e. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

f. Upper anchor of the front seat belt Front Seat Belt Removal/Installation [Standard Deployment Control System] Front Seat Belt Removal/Installation [Two-Step Deployment Control System]

g. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

h. Rear seat cushion Rear Seat Cushion Removal/Installation

i. Tire house trim Tire House Trim Removal/Installation

j. C-pillar trim C-Pillar Trim Removal/Installation

k. Map light Map Light Removal/Installation

l. Sunvisor Service and Repair

m. Assist handle Service and Repair

n. Headliner Service and Repair

6. Remove the clips A and B.






7. Disconnect the connector A. (with SIRIUS satellite radio system)

8. Disconnect the connector B. (See Connector B Removal Note.)

9. Remove the clip C.

10. Remove the bolt.

11. Remove the Antenna amplifier.

12. Install in the reverse order of removal.

Connector B Removal Note

1. Remove the connector B in the direction of the arrow (2) shown in the figure while pressing the glass antenna terminal in the direction of the arrow (1).