Sunroof / Moonroof Motor: Service and Repair

SUNROOF MOTOR REMOVAL/INSTALLATION

1. Disconnect the negative battery cable. Removal and Replacement (See Removal and Replacement. ) Removal and Replacement

2. Remove the rain sensor cover. (Vehicles with auto light/wiper system) Service and Repair

3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)

4. Partially peel back the seaming welts.

5. Remove the following parts:
a. Sunroof seaming welt

b. A-pillar trim A-Pillar Trim Removal/Installation

c. Front scuff plate Front Scuff Plate Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

e. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

f. Upper anchor of the front seat belt Front Seat Belt Removal/Installation [Standard Deployment Control System] Front Seat Belt Removal/Installation [Two-Step Deployment Control System]

g. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

h. Rear seat cushion Rear Seat Cushion Removal/Installation

i. Tire house trim Tire House Trim Removal/Installation

j. Trunk side upper trim (5HB)

k. C-pillar trim C-Pillar Trim Removal/Installation

l. Map light Map Light Removal/Installation

m. Sunvisor Service and Repair

n. Assist handle Service and Repair

o. Headliner Service and Repair

6. Disconnect the sunroof motor connector.






7. Remove the screws, and then remove the sunroof motor.

8. Install in the reverse order of removal.

NOTE:
- If the glass panel or the sunroof motor is moved with the sunroof motor removed, initial position setting of the sunroof motor will be required. Perform initial position setting referring to the Sunroof Motor Assembly Note. Overhaul