LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1982 >> Capri L6-200 3.3L >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Testing and Inspection >> Component Tests and General Diagnostics >> Primary Circuit Tests >> Test 4, Ballast Resistor

Test 4, Ballast Resistor

Procedure
1. Disconnect module connector with red and white wires then, ignition coil connector.
2. Using a suitable ohmmeter, measure resistance between Batt. terminal of ignition coil connector and wiring harness connector wire that joins red wire in module connector.
3. If resistance is 0.8---1.6 ohms, ballast resistor is satisfactory. If resistance is less than 0.8 ohms or greater than 1.6 ohms, replace ballast resistor.




scientia non olet · About LEMON Manuals