J13 - Check FPM Circuit Continuity

- Key "OFF".

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Disconnect fuel pump relay.

- Measure resistance between test pin 8 at the breakout box and power-to-pump circuit at the fuel pump relay vehicle harness connector.

- Is resistance less than 5.0 ohms?

Yes -- For dual Heated Oxygen Sensor (HO2S) applications: Reconnect fuel relay. Go to J25. J25 - Check Left/Front Heated Oxygen Sensor or Short to Power

All others: Replace PCM. Remove breakout box. Reconnect fuel pump relay. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)

No -- Service open circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)