Diagnostic Procedure 5
DIAGNOSTIC PROCEDURE 5 / With CONSULT-II Scan ToolInspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode
1. Turn ignition switch OFF.
2. Connect "CONSULT-II" to data link connector.
3. Turn ignition switch ON.
4. Touch "START".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [PAST]".
7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.
If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
8. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to SRS-29, "CONSULT-II Diagnostic Code Chart ("SELF-DIAG [PAST]" or "TROUBLE DIAG RECORD")".
12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
13. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
14. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
Intermittent Malfunction Diagnostic Code Chart
15. Go to "DIAGNOSTIC PROCEDURE 3", for final checking.
Diagnostic Procedure 3