Operation CHARM: Car repair manuals for everyone.

Diagnostic Procedure 3

DIAGNOSTIC PROCEDURE 3 / With CONSULT-II Scan Tool

Final checking after repairing SRS by using CONSULT-II -Diagnosis mode






1. After repairing SRS, connect both battery cables.
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch "ON".






4. Touch "START".






5. Touch "AIR BAG".






6. Touch "SELF-DIAG [CURRENT]".






7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 8.


If any malfunction is detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to "DIAGNOSTIC PROCEDURE 2", and repair malfunctioning part completely.
Diagnostic Procedure 2






8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").


If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.






9. Touch "BACK" key of CONSULT-II to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".






10. Check that no malfunction is detected on "SELF-DIAG [PAST]".
11. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
12. Turn ignition switch OFF then turn off and disconnect CONSULT-II.
13. Go to Diagnostic Procedure 1 - SRS Operation Check / "Checking Air Bag Operation by Using "AIR BAG" Warning Lamp-User Mode".
[1][2]Component Tests and General Diagnostics