Diagnostic Procedure 6

Inspecting SRS malfunctioning parts by using AIR BAG warning lamp - Diagnosis mode






NOTE: SRS will not enter Diagnosis mode if no malfunction is detected in User mode.

1. Turn ignition switch ON.
2. After AIR BAG warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
3. Wait more than 3 seconds.
4. Repeat steps 1 to 3 two times. (Perform 3 times in total.)
5. Turn ignition switch ON. SRS is now in Diagnosis mode.
6. AIR BAG warning lamp operates in Diagnosis mode as follows:






NOTE: If SRS does not enter Diagnosis mode even though malfunction is detected in User mode, check the battery voltage.

If the battery voltage is less than 9 V, charge the battery. Then go to DIAGNOSTIC PROCEDURE 7,
Diagnostic Procedure 7

If the battery voltage is OK, replace the diagnosis sensor unit.

7. Malfunctioning part is indicated by the number of flashes (part d or f). Compare the number of flashes to Air Bag Warning Lamp Flash Code Chart, and locate malfunctioning part.
8. Turn ignition switch OFF, and disconnect both battery cables.
9. Repair the system as outlined by the Repair order in Warning Lamp Flash Code Chart that corresponds to the flash code. For replacement procedure of component parts, Locations
10. After repairing the system, go to DIAGNOSTIC PROCEDURE 7.
Diagnostic Procedure 7

Air Bag Warning Lamp Flash Code (Diagnosis Mode) Part 1:

Air Bag Warning Lamp Flash Code (Diagnosis Mode) Part 2:

Air Bag Warning Lamp Flash Code (Diagnosis Mode) Part 3:

Air Bag Warning Lamp Flash Code (Diagnosis Mode) Part 4: