With Manufacturer's Scan Tool

CONSULT-II Function (A/T)
CONSULT-II can display each diagnostic item using the diagnostic test mode shown following.





FUNCTION

CONSULT-II REFERENCE VALUE







NOTICE:
1. The CONSULT-II electrically displays shift timing and lock-up timing (that is, operation timing of each solenoid).
Check for time difference between actual shift timing and the CONSULT-II display. If the difference is noticeable, mechanical parts (except solenoids, sensors, etc.) may be malfunctioning. Check mechanical parts using applicable diagnostic procedures.
2. Shift schedule (which implies gear position) displayed on CONSULT-II and that indicated in Service Manual may differ slightly. This occurs because of the following reasons:
- Actual shift schedule has more or less tolerance or allowance,
- Shift schedule indicated refers to the point where shifts start, and
- Gear position displayed on CONSULT-II indicates the point where shifts are completed.

3. Display of solenoid valves on CONSULT-II changes at the start of shifting, while gear position is displayed upon completion of shifting (which is computed by TCM).

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.

^ For details, refer to the separate "CONSULT-II Operations Manual".





1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower driver panel.





3. Turn ignition switch "ON". (Do not start engine.)
4. Touch "START (NISSAN BASED VHCL)".





5. Touch "A/T".
If "A/T" is not indicated, go to "GI-39, CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System





6. Perform each diagnostic test mode according to each service procedure.

SELF-DIAGNOSTIC RESULT MODE
After performing "SELF-DIAGNOSTIC RESULT MODE", place check marks for results on the "DIAGNOSTIC WORKSHEET". Reference pages are provided following the items.

Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE".





2. Touch"SELF-DIAG RESULTS". Display shows malfunction experienced since the last erasing operation.











Display Items List

How to Erase Self-diagnostic Results
1. Perform "CONSULT-II SETTING PROCEDURE".





2. Touch"SELF-DIAG RESULTS".





3. Touch "ERASE". (The self-diagnostic results will be erased.)


DATA MONITOR MODE

Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE".





2. Touch "DATA MONITOR".

NOTE: When malfunction is detected, CONSULT-II performs "REAL-TIME DIAGNOSIS". Also, any malfunction detected while in this mode will be displayed at real time.














Display Items List

CAN DIAGNOSTIC SUPPORT MONITOR MODE

Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE"





2. Touch "CAN DAIG SUPPORT MNTR". Refer to "Precautions When Using CONSULT-II".

DTC WORK SUPPORT MODE

Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE".





2. Touch "DTC WORK SUPPORT".





3. Touch select item menu.





4. Touch "START".





5. Perform driving test according to "DTC CONFIRMATION PROCEDURE" in "TROUBLE DIAGNOSIS FOR DTC".





^ When testing conditions are satisfied, CONSULT-II screen changes from "OUT OF CONDITION" to "TESTING".





6. Stop vehicle.





^ If "NG" appears on the screen, malfunction may exist. Go to "Diagnostic Procedure".





7. Perform test drive to check gear shift feeling in accordance with instructions displayed.
8. Touch "YES" or "NO".
9. CONSULT-II procedure ended.





^ If "NG" appears on the screen, malfunction may exist. Go to "Diagnostic Procedure".





Display Items List