Vehicle Speed Does Not Change In "D" Position
Vehicle Speed Does Not Change in "D" PositionSYMPTOM: Vehicle speed does not change in "D" position while the cruise test.
DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to CVT-47, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system. Refer to CVT-47, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
NO >> GO TO 2.
2. CHECK CVT POSITION
Check CVT position. Refer to CVT-171, "Checking of CVT Position". Testing and Inspection
OK or NG
OK >> GO TO 3.
NG >> Adjust CVT position. Refer to CVT-171, "Adjustment of CVT Position". Adjustments
3. CHECK CVT FLUID LEVEL
Check CVT fluid level. Refer to MA-19, "Checking CVT Fluid".
OK or NG
OK >> GO TO 4.
NG >> Refill CVT fluid.
4. CHECK LINE PRESSURE
Check line pressure at idle. Refer to CVT-36, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
OK or NG
OK >> GO TO 5.
NG >> Check the malfunctioning item. Refer to CVT-36, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
5. CHECK STALL REVOLUTION
Check stall revolution. Refer to CVT-36, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
OK or NG
OK >> GO TO 6.
NG >> Check the malfunctioning item. Refer to CVT-36, "Inspections before Trouble Diagnosis". Inspections Before Trouble Diagnosis
6. CHECK SYMPTOM
Check again. Refer to CVT-43, "Cruise Test". Cruise Test
OK or NG
OK >> INSPECTION END
NG >> GO TO 7.
7. CHECK TCM
1. Check TCM input/output signals. Refer to CVT-45, "TCM Terminal and Reference Value". Continuously Variable Transmission
2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace the transaxle assembly.
NG >> Repair or replace damaged parts.