Sedan With Intelligent Key
B2602 SHIFT POSITION
Description
BCM confirms the shift position with the following 2 signals.
- CVT selector lever
- Speed signal from meter
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to Sedan With Intelligent Key.
- If DTC B2602 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to Sedan With Intelligent Key.
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine under the following conditions and wait for at least 10 seconds.
- CVT selector lever is in the P or N position
- Depress the brake pedal.
2. Drive the vehicle for at least 10 seconds at a speed greater than 4 km/h (2 MPH).
3. Check "Self diagnostic result" with CONSULT-III.
Is DTC detected?
YES - Refer to Sedan With Intelligent Key.
NO - Inspection End.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to NVIS - With Intelligent Key System.
1.CHECK DTC WITH "COMBINATION METER"
Check "Self diagnostic result" with CONSULT-III. Refer to Testing and Inspection.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace malfunctioning parts.
2.CHECK CVT SHIFT SELECTOR POWER SUPPLY
1. Turn ignition switch to ACC.
2. Disconnect CVT shift selector (park position switch) harness connector.
3. Check voltage between CVT shift selector (park position switch) harness connector and ground.
Is the inspection result normal?
YES - GO TO 4
NO - GO TO 3
3.CHECK CVT SHIFT SELECTOR POWER SUPPLY CIRCUIT
1. Disconnect BCM harness connector.
2. Check continuity between BCM harness connector M19 (A) terminal 84 and CVT shift selector (park position switch) harness connector M23 (B) terminal 8.
3. Check continuity between BCM harness connector M19 (A) terminal 84 and ground.
Is the inspection result normal?
YES - Replace BCM. Refer to BCM.
NO - Repair harness or connector.
4.CHECK CVT SHIFT SELECTOR CIRCUIT
1. Disconnect BCM harness connector.
2. Check continuity between CVT shift selector (park position switch) harness connector and BCM harness connector.
3. Check continuity between CVT shift selector (park position switch) harness connector and ground.
Is the inspection result normal?
YES - GO TO 5
NO - Repair harness or connector.
5.CHECK CVT SHIFT SELECTOR
Refer to Sedan With Intelligent Key.
Is the inspection result normal?
YES - GO TO 6
NO - Replace CVT shift selector. Refer to Removal And Installation (RE0F09B) or Removal And Installation (RE0F10A).
6.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- Inspection End.