CVT RE0F09B
P1723 SPEED SENSOR
Description
The secondary speed sensor detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed.
The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.
Is "P1723" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.
Diagnosis Procedure
1.CHECK STEP MOTOR FUNCTION
Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
Is "P1778" detected?
YES - Repair or replace damaged parts. Refer to CVT RE0F09B.
NO - GO TO 2.
2.CHECK SECONDARY SPEED SENSOR SYSTEM
Check secondary speed sensor system. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
T M -1 7 8
3.CHECK PRIMARY SPEED SENSOR SYSTEM
Check primary speed sensor system. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK ENGINE SPEED SIGNAL SYSTEM
Check engine speed signal system. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace damaged parts.
5.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.