CVT RE0F09B

P0715 INPUT SPEED SENSOR A





Description
The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.





With GST
Follow the procedure "With CONSULT-III".
Is "P0715" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK PRIMARY SPEED SENSOR





1. Start engine.
2. Check voltage between TCM harness connector F16 terminal
25 and 26.










3. If OK, check the pulse when vehicle cruises.





Is the inspection result normal?
OK - GO TO 7.
NG - 1 - Battery voltage is not supplied: GO TO 2.
NG - 2 - Battery voltage is supplied, but there is a malfunction in the frequency: GO TO 4.
2. CHECK HARNESS BETWEEN TCM AND CVT UNIT HARNESS CONNECTOR (SENSOR POWER AND
SENSOR GROUND) (PART 1)





1. Turn ignition switch OFF.
2. Disconnect TCM harness connector and CVT unit harness connector.
3. Check continuity between TCM harness connector F16 (A) terminal 25 and 26 and CVT unit harness connector F46 (B) terminal 19 and 20.






Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3. CHECK HARNESS BETWEEN TCM AND CVT UNIT HARNESS CONNECTOR (SENSOR POWER AND
SENSOR GROUND) (PART 2)





Check continuity between TCM harness connector F16 terminal 25 and 26 and ground.





Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace damaged parts.
4. CHECK HARNESS BETWEEN TCM AND CVT UNIT HARNESS CONNECTOR (PRIMARY SPEED SENSOR) (PART 1)





1. Turn ignition switch OFF.
2. Disconnect TCM harness connector and CVT unit harness connector.
3. Check continuity between TCM harness connector F16 (A) terminal 33 and CVT unit harness connector F46 (B) terminal 22.





Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace damaged parts.
5. CHECK HARNESS BETWEEN TCM AND CVT UNIT HARNESS CONNECTOR (PRIMARY SPEED SENSOR) (PART 2)





Check continuity between TCM harness connector F16 terminal 33 and ground.





Is the inspection result normal?
YES - GO TO 6.
- Repair or replace damaged parts.
6. CHECK THE TCM SHORT
Replace same type TCM, perform self-diagnosis check. Erase self-diagnostic results and then drive the vehicle [10 km/h (6 MPH) or more], perform self-diagnosis check. Refer to CVT RE0F09B.
Is the "P0715" detected again?
YES - GO TO 7.
NO - Check intermittent incident. Refer to Intermittent Incident.
7.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.