B2602
B2602 SHIFT POSITION
Description
BCM confirms the shift position with the following 4 signals.
- Selector lever
- Transmission range switch
- P position signal from IPDM E/R (CAN)
- P position signal from TCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. With Intelligent Key System.
- If DTC B2602 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. With Intelligent Key System.
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine under the following conditions and wait 10 seconds or more.
- Selector lever is in the P or N position
- Do not depress brake pedal
2. Check "Self-diagnosis result" using CONSULT-III.
Is DTC detected?
YES - Go to B2602.
NO - INSPECTION END
Diagnosis Procedure
1.CHECK DTC WITH "ABS ACTUATOR AND ELECTRIC UNIT"
Check "Self-diagnosis result" using CONSULT-III. Testing and Inspection.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace the malfunctioning parts.
2.CHECK CVT SHIFT SELECTOR POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect CVT shift selector (detention switch) connector.
3. Check voltage between CVT shift selector (detention switch) harness connector and ground.
Is the inspection result normal?
YES - GO TO 4.
NO - GO TO 3.
3.CHECK CVT SHIFT SELECTOR POWER SUPPLY CIRCUIT
1. Disconnect BCM connector.
2. Check continuity between CVT shift selector (detention switch) harness connector and BCM harness connector.
3. Check continuity between CVT shift selector (detention switch) harness connector and ground.
Is the inspection result normal?
YES - Replace BCM. Removal And Installation.
NO - Repair or replace harness.
4.CHECK CVT SHIFT SELECTOR CIRCUIT
1. Disconnect BCM connector and IPDM E/R connector.
2. Check continuity between CVT shift selector (detention switch) harness connector and BCM harness connector.
3. Check continuity between CVT shift selector (detention switch) harness connector and ground.
Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace harness.
5.CHECK CVT SHIFT SELECTOR (DETENTION SWITCH)
B2602.
Is the inspection result normal?
YES - GO TO 6.
NO - Replace CVT shift selector. Removal And Installation.
6.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END
Component Inspection
1.CHECK CVT SHIFT SELECTOR (DETENTION SWITCH)
1. Turn ignition switch OFF.
2. Disconnect CVT shift selector connector.
3. Check continuity between CVT shift selector (detention switch) terminals.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace CVT shift selector. Removal And Installation.