Operation CHARM: Car repair manuals for everyone.

C1105


C1105, C1106, C1107, C1108 WHEEL SENSOR-2





Description
When the sensor rotor rotates, the magnetic field changes. It converts the magnetic field changes to current signals (rectangular wave) and transmits them to the ABS actuator and electric unit (control unit).




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.





Is above displayed on the self-diagnosis display?
YES - Proceed to diagnosis procedure. C1105.
NO - Inspection End




Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Antilock Brakes / Traction Control Systems.

CAUTION:
Do not check between wheel sensor terminals.
1.CONNECTOR INSPECTION
1. Disconnect ABS actuator and electric unit (control unit) connector and wheel sensor of malfunctioning code.
2. Check terminals for deformation, disconnection, looseness or damage.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace as necessary.
2.CHECK WHEEL SENSOR OUTPUT SIGNAL
1. Connect ABS active wheel sensor tester (J-45741) to wheel sensor using appropriate adapter.
2. Turn on the ABS active wheel sensor tester power switch.

NOTE:
The green POWER indicator should illuminate. If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding.
3. Spin the wheel of the vehicle by hand and observe the red SENSOR indicator on the ABS active wheel sensor tester. The red SENSOR indicator should flash on and off to indicate an output signal.

NOTE:
If the red SENSOR indicator illuminates but does not flash, reverse the polarity of the tester leads and retest.
Does the ABS active wheel sensor tester detect a signal?
YES - GO TO 3
NO - Replace the wheel sensor. Wheel Sensor.
3.CHECK TIRES
Check the inflation pressure, wear and size of each tire.
Is the inspection result normal?
YES - GO TO 4
NO - Adjust tire pressure, or replace tire(s).
4.CHECK WHEEL BEARINGS
Check wheel bearing axial end play. Front Wheel Hub (front) or Procedures (rear).
Is the inspection result normal?
YES - GO TO 5
NO - Repair or replace as necessary. Front Wheel Hub (front) or Specifications (rear).
5.CHECK WIRING HARNESS FOR SHORT CIRCUIT





1. Disconnect ABS actuator and electric unit (control unit) connector and wheel sensor of malfunctioning code.
2. Check continuity between front wheel sensor connector terminals (A), rear wheel sensor connector terminals (B) and ground.

: Continuity should not exist.

Is the inspection result normal?
YES - GO TO 6
NO - Repair the circuit.
6.CHECK WIRING HARNESS FOR OPEN CIRCUIT
Check continuity between ABS actuator and electric unit (control unit) connector and the malfunctioning wheel sensor connector.





Is the inspection result normal?
YES - Replace the ABS actuator and electric unit (control unit). Removal And Installation.
NO - Repair the circuit.




Component Inspection
1.CHECK DATA MONITOR
On "DATA MONITOR", select "FR LH SENSOR", "FR RH SENSOR", "RR LH SENSOR", and "RR RH SENSOR", and check the vehicle speed.





Is the inspection result normal?
YES - Inspection End
NO - Go to diagnosis procedure. C1105.




Special Repair Requirement
1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit). Special Repair Requirement.
- END