Transmission Position Sensor/Switch: Service and Repair

ON-VEHICLE SERVICE


Transmission Range Switch


COMPONENTS











REMOVAL AND INSTALLATION

Removal
1. Disconnect the battery negative terminal.
2. Remove air duct (inlet). Component Removal And Installation.





3. Remove control cable (1) from manual shaft. Removal And Installation.
4. Disconnect transmission range switch harness connector (2).
5. Remove transmission range switch bolts.
6. Set manual shaft in "P" position.
7. Remove transmission range switch from A/T.

Installation
Installation is in the reverse order of removal.

NOTE:
- Align transmission range switch position when installing.
- After installation is completed, adjust and check the transmission range switch and A/T position. Refer to "TRANSMISSION RANGE SWITCH ADJUSTMENT", Adjustments and Testing and Inspection.
- After installation is completed, check continuity of transmission range switch. Component Inspection.

TRANSMISSION RANGE SWITCH ADJUSTMENT
1. Remove air duct (inlet). Component Removal And Installation.





2. Set selector lever and manual shaft (1) in "N" position.
3. Remove control cable from manual shaft (1). Removal And Installation.
4. Loosen transmission range switch bolts.

Arrow Indicates Bolt

5. Insert the pin (3) [4 mm (0.16 in) dia.] straight into manual shaft
(1) adjustment hole.
6. Rotate transmission range switch (2) until the pin (3) can also be inserted straight into hole in transmission range switch (2).
7. Tighten transmission range switch bolts to the specified torque.
Refer to "COMPONENTS".
8. Remove the pin (3) from adjustment hole after adjusting transmission range switch (2).
9. Install the control cable. Removal And Installation.
10. Adjust and check A/T position. Adjustments and Testing and Inspection
11. Check continuity of transmission range switch (2). Component Inspection.
12. Install the air duct (inlet). Component Removal And Installation.