Roadster

TRUNK LID

TRUNK LID ASSEMBLY : Adjustment











Check the clearance and surface height between trunk lid and each part by visually and touching.
If the clearance and surface height are out of specification, adjust them according to the procedures shown below.










1.Loosen trunk lid hinge mounting bolts (trunk lid side).
2.Remove trunk rear plate. Trunk Rear Plate.
3.Loosen trunk lid striker mounting bolts.
4.Lift up trunk lid approximately 100 - 150 mm (3.937 - 5.906 in) height then close it lightly and check that it is engaged firmly with trunk lid closed.
5.Check the clearance and surface height.
6.Finally tighten trunk lid hinge and trunk lid striker.
7.Install trunk rear plate. Trunk Rear Plate.

TRUNK LID STRIKER ADJUSTMENT

Adjust trunk lid striker so that it becomes parallel with trunk lid lock insertion direction.