Ignition Control Module Replacement - Bank 2

REMOVAL PROCEDURE




1. Remove the ignition cassette.
2. Remove the ignition control module retaining screws.
3. Remove the ignition control module.

INSTALLATION PROCEDURE




1. Install the ignition control module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the ignition control module retaining screws.

Tighten
Tighten the ignition control module retaining screws to 0.8 N.m (7 lb in).

IMPORTANT: Ensure that the ignition cassette grounding spring and the insulator are in place when installing the ignition cassette.

3. Connect the spark plug boots to the spark plugs.
4. Install the ignition cassette.