Ignition Switch: Service and Repair

IGNITION AND START SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the trim covers from the steering column.
3. Disconnect the ignition switch electrical connector.




4. Remove the 2 screws (8,9) and the ignition switch (7).

INSTALLATION PROCEDURE




1. Install the ignition switch (7) and the 2 screws (8,9).
2. Connect the ignition switch electrical connector.
3. Install the trim covers to the steering column.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.