Rear Axle Hub

AXLE: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL

2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

3. LOOSEN WIRE ADJUSTING NUT Removal

4. REMOVE REAR FLOOR SIDE MEMBER COVER Removal

5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal

6. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Removal

7. REMOVE REAR DISC Removal

8. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the axle hub.





Maximum:

0.05 mm (0.00197 in.)

NOTICE:
Ensure that the dial indicator is set perpendicular to the measurement surface.

HINT
If the looseness exceeds the maximum, replace the axle hub assembly.

9. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.





Maximum:

0.07 mm (0.00276 in.)

NOTICE:
Ensure that the dial indicator is set perpendicular to the measurement surface.

HINT
If the runout exceeds the maximum, replace the axle hub assembly.

10. INSTALL REAR DISC Installation

11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation

12. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

13. INSTALL REAR FLOOR SIDE MEMBER COVER Installation

14. INSPECT PARKING BRAKE LEVER TRAVEL Adjustments

15. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments

16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

17. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)