Installation

AXLE: REAR AXLE HUB: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. INSTALL REAR DISC BRAKE DUST COVER SUB-ASSEMBLY

2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the hub and bearing assembly with the 4 bolts.





Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

NOTICE:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

3. INSTALL SKID CONTROL SENSOR WIRE Installation

4. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

5. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

6. INSTALL REAR DISC Installation

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

(a) Install the rear disc brake caliper with the 2 bolts.





Torque : 57 Nm (585 kgf-cm, 42 ft-lbf)

8. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

9. INSPECT PARKING BRAKE LEVER TRAVEL Adjustments

10. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments

11. INSTALL REAR FLOOR SIDE MEMBER COVER Installation

12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

13. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

14. INSPECT REAR WHEEL ALIGNMENT

Rear Wheel Alignment

15. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure