Removal

3MZ-FE ENGINE MECHANICAL: ENGINE UNIT: REMOVAL

REMOVAL

1. INSTALL ENGINE STAND
2. REMOVE NO. 2 ENGINE HANGER






(a) Remove the 2 bolts and No. 2 engine hanger.
3. REMOVE EMISSION CONTROL VALVE SET Removal

4. REMOVE INTAKE AIR SURGE TANK Removal

5. REMOVE INTAKE MANIFOLD Removal

6. REMOVE OUTLET WATER Removal

7. REMOVE IGNITION COIL ASSEMBLY Removal

8. REMOVE NO. 3 MANIFOLD CONVERTER INSULATOR Removal

9. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

10. REMOVE NO. 2 EXHAUST MANIFOLD CONVERTER Removal

11. REMOVE NO. 2 MANIFOLD STAY
(a) Remove the 2 bolts and No. 2 manifold stay.
12. REMOVE ENGINE MOUNTING BRACKET RH






(a) Remove the 3 bolts and engine mounting bracket RH.
13. REMOVE ENGINE MOUNTING STAY BRACKET






(a) Remove the bolt, nut and engine mounting stay bracket.
14. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET






(a) Remove the 4 bolts and No. 1 compressor mounting bracket.
15. REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET






(a) Remove the 2 bolts and No. 2 intake air connector bracket.
16. REMOVE INLET WATER PIPE Removal

17. REMOVE INLET WATER Removal

18. REMOVE THERMOSTAT Removal

19. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY






(a) Using a 24 mm deep socket wrench, remove the oil pressure switch.
20. REMOVE KNOCK CONTROL SENSOR Removal