Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION
INSTALLATION
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the power switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
(c) Install the center airbag sensor assembly with the 3 bolts.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
NOTE:
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- When the power switch is first turned on (READY) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
(d) Check that there are no loose parts after installing the center airbag sensor assembly.
(e) Connect the holder (with connectors).
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
(f) Check that the waterproof sheet is properly set.
2. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
3. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
4. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System) Installation
5. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System) Installation
6. INSTALL LOWER REAR CONSOLE BOX Installation
7. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System) Installation
8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
9. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
10. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side Installation Part 1, Step 1-65.
12. INSTALL FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side Installation Part 1, Step 1-65.
13. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation
14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation Part 1, Step 1-65
15. INSTALL FRONT DOOR SCUFF PLATE LH Installation Part 1, Step 1-65
16. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization
18. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.