Installation

WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS: INSTALLATION

INSTALLATION

1. INSTALL QUARTER WINDOW ASSEMBLY
(a) Using a brush or sponge, apply Primer M to the exposed part of the vehicle body.





Standard measurement:





NOTICE:
- Apply Primer M in front of the bead as shown in the illustration.
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover Primer M.
- Do not apply too much primer.

(b) Using a brush or sponge, apply Primer G to the contact surface of the glass.





Standard measurement:





HINT: If the primer is applied to an area that is specified, wipe off the primer with a non-residue solvent before it dries.
NOTICE:
- To prevent the glass from breaking at low temperatures, ensure that no primer adheres to the contact surface between the moulding and glass during application.
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover Primer G.
- Do not apply too much primer.

(c) Apply adhesive to the quarter window assembly.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration.





Standard measurement:





HINT: After cutting off the tip, use all the adhesive within the time written in the table below.

Usage time frame:





(2) Load the sealer gun with the cartridge.
(3) Apply adhesive to the quarter window glass as shown in the illustration.
(d) Install the quarter window glass to the vehicle body.
(1) Hold the quarter window assembly in place securely with protective tape or equivalent until the adhesive hardens.
NOTICE:
- Allow the primer to dry for 3 minutes or more.
- Check that the clips are attached to the body correctly.
- Check the clearance between the body and glass.
(2) Lightly press the outer surface of the glass to ensure a close fit.





(3) Using a scraper, remove any excess or protruding adhesive.
HINT: Apply adhesive onto the glass rim.
NOTE: Do not drive the vehicle within the time written in the table below.

Minimum time:






2. INSPECT FOR LEAK AND REPAIR
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leaks with auto glass sealer.
3. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Installation Part 1, Step 1-65

4. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Installation Part 1, Step 1-65

5. INSTALL VISOR HOLDER Installation Part 1, Step 1-65

6. INSTALL SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof) Installation Part 1, Step 1-65

7. INSTALL ROOF HEADLINING TRIM CLIP STOPPER Installation Part 1, Step 1-65

8. INSTALL ASSIST GRIP ASSEMBLY (w/ Sliding Roof) Installation Part 1, Step 1-65

9. INSTALL REAR ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof) Installation Part 1, Step 1-65

10. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof) Installation Part 1, Step 1-65

11. INSTALL TELEVISION DISPLAY ASSEMBLY (w/ Rear Seat Entertainment System) Installation

12. INSTALL TELEVISION BASE (w/ Rear Seat Entertainment System) Installation

13. INSTALL NO. 2 ROOM LIGHT ASSEMBLY Installation Part 1, Step 1-65

14. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (for Standard) Installation Part 1, Step 1-65

15. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (for Independent Type) Installation Part 1, Step 1-65

16. INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror) Installation

17. INSTALL VISOR ASSEMBLY LH Installation Part 1, Step 1-65

18. INSTALL VISOR BRACKET COVER (for LH Side) Installation Part 1, Step 1-65

19. INSTALL VISOR ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.

20. INSTALL VISOR BRACKET COVER (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.

21. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation Part 1, Step 1-65

22. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (w/o Power Back Door) Installation Part 1, Step 1-65

23. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (w/ Power Back Door) Installation Part 1, Step 1-65

24. INSTALL QUARTER PILLAR GARNISH LH Installation Part 1, Step 1-65

25. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Installation Part 1, Step 1-65

26. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH Installation

27. INSTALL FRONT DECK SIDE TRIM COVER LH Installation Part 1, Step 1-65

28. INSTALL NO. 2 DECK SIDE TRIM HOOK Installation Part 1, Step 1-65

29. INSTALL ROPE HOOK ASSEMBLY (for LH Side) Installation Part 1, Step 1-65

30. INSTALL REAR DECK TRIM COVER (w/o Remote Folding Function) Installation Part 1, Step 1-65

31. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH (w/ Remote Folding Function) Installation Part 1, Step 1-65

32. INSTALL REAR POWER OUTLET SOCKET COVER Installation

33. INSTALL REAR POWER POINT SOCKET ASSEMBLY Installation

34. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH Installation

35. INSTALL SIDE TRIM COVER LH (w/o Rear Seat Entertainment System) Installation Part 1, Step 1-65

36. INSTALL POWER OUTLET SOCKET BEZEL (w/ Rear Seat Entertainment System) Installation Part 1, Step 1-65

37. INSTALL DECK SIDE TRIM LH Installation Part 1, Step 1-65

38. INSTALL DECK SIDE TRIM COVER LH Installation Part 1, Step 1-65

39. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat)
HINT: Use the same procedure for the RH side and the LH side.

40. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat)
HINT: Use the same procedure for the RH side and the LH side.

41. INSTALL QUARTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

42. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation Part 1, Step 1-65

43. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.

44. INSTALL FRONT DECK SIDE TRIM COVER RH
HINT: Use the same procedure for the RH side and the LH side.

45. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
HINT: Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.

46. INSTALL ROPE HOOK ASSEMBLY (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.

47. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH Installation Part 1, Step 1-65

48. INSTALL REAR ROOM TEMPERATURE SENSOR (w/ Rear Automatic Air Conditioning System) Installation

49. INSTALL SIDE TRIM COVER RH (w/o Rear Automatic Air Conditioning System) Installation Part 1, Step 1-65

50. INSTALL DECK SIDE TRIM RH
HINT: Use the same procedure for the RH side and the LH side.

51. INSTALL DECK SIDE TRIM COVER RH
HINT: Use the same procedure for the RH side and the LH side.

52. INSTALL REAR SEAT SIDE GARNISH CAP (w/o Rear Air Conditioning System) Installation Part 1, Step 1-65

53. INSTALL REAR SEAT SIDE GARNISH CAP (w/ Rear Air Conditioning System) Installation Part 1, Step 1-65

54. INSTALL REAR FLOOR FINISH PLATE Installation Part 1, Step 1-65

55. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat) Installation

56. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

57. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) Installation

58. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat) Installation

59. INSTALL NO. 1 DECK BOARD (w/o Rear No. 2 Seat) Installation Part 1, Step 1-65

60. INSTALL NO. 1 DECK BOARD (w/ Rear No. 2 Seat) Installation Part 1, Step 1-65

61. INSTALL DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat) Installation Part 1, Step 1-65

62. INSTALL REAR MAT Installation Part 1, Step 1-65

63. INSTALL DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat) Installation Part 1, Step 1-65

64. INSTALL DECK SIDE TRIM BOX LH Installation Part 1, Step 1-65

65. INSTALL REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat) Installation Part 1, Step 1-65

66. INSTALL DECK SIDE TRIM BOX RH Installation Part 1, Step 1-65

67. INSTALL JACK CARRIER ASSEMBLY Installation Part 1, Step 1-65

68. INSTALL JACK ASSEMBLY Installation Part 1, Step 1-65

69. INSTALL JACK CARRIER CUSHION Installation Part 1, Step 1-65

70. INSTALL JACK CARRIER SUPPORT
71. INSTALL REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat) Installation Part 1, Step 1-65

72. INSTALL REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat) Installation Part 1, Step 1-65

73. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
74. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY Installation Part 1, Step 1-65

75. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY Installation Part 1, Step 1-65

76. INSTALL DECK BOARD ASSEMBLY Installation Part 1, Step 1-65

77. INSTALL CENTER PILLAR GARNISH LH Installation Part 1, Step 1-65

78. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation

79. INSTALL LOWER CENTER PILLAR GARNISH LH Installation Part 1, Step 1-65

80. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation Part 1, Step 1-65

81. INSTALL REAR DOOR SCUFF PLATE LH Installation Part 1, Step 1-65

82. INSTALL FRONT PILLAR GARNISH LH Installation Part 1, Step 1-65

83. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation Part 1, Step 1-65

84. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation Part 1, Step 1-65

85. INSTALL FRONT DOOR SCUFF PLATE LH Installation Part 1, Step 1-65

86. INSTALL CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

87. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.

88. INSTALL LOWER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.

89. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation Part 1, Step 1-65

90. INSTALL REAR DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.

91. INSTALL FRONT PILLAR GARNISH RH Installation Part 1, Step 1-65

92. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation Part 1, Step 1-65

93. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.

94. INSTALL FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.

95. INSTALL REAR NO. 1 SEAT ASSEMBLY LH Installation

96. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY LH (w/ Remote Folding Function) Installation

97. INSPECT REAR SEAT SLIDE ADJUSTER LOCK (for LH Side) Installation

98. INSTALL REAR SEAT LEG SIDE COVER LH Installation

99. INSTALL RECLINING HINGE COVER LH Installation

100. INSTALL REAR INNER TRACK BRACKET COVER LH Installation

101. INSTALL REAR OUTER TRACK BRACKET COVER LH Installation

102. INSTALL REAR SEAT TRACK BRACKET COVER Installation

103. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)
104. INSTALL REAR CENTER SEAT ASSEMBLY
105. INSTALL REAR NO. 1 SEAT ASSEMBLY RH Installation

106. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY RH (w/ Remote Folding Function)
HINT: Use the same procedure for the RH side and the LH side.

107. INSPECT REAR SEAT SLIDE ADJUSTER LOCK (for RH Side) Installation

108. INSTALL REAR SEAT LEG SIDE COVER RH Installation

109. INSTALL REAR INNER TRACK BRACKET COVER RH Installation

110. INSTALL REAR OUTER TRACK BRACKET COVER RH Installation

111. INSTALL REAR SEAT TRACK BRACKET COVER Installation

112. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)