Installation

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to an O-ring of the crankshaft position sensor.





(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the crankshaft position sensor connector.
2. INSTALL COOLER COMPRESSOR ASSEMBLY
(a) Install the cooler compressor assembly with the 4 bolts.
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
(b) Connect the cooler compressor assembly connector.





(c) Install the suction hose sub-assembly with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
3. INSTALL ENGINE UNDER COVER ASSEMBLY REAR
(a) Install the engine under cover assembly rear with the 4 bolts.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)
4. INSTALL GENERATOR ASSEMBLY Installation