Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL YAW RATE SENSOR





(a) Install the yaw rate sensor with 2 bolts.
Torque: 13.3 Nm (136 kgf-cm, 10 ft-lbf)
(b) Connect the yaw rate sensor connector.
2. INSTALL CONSOLE BOX ASSEMBLY REAR
3. INSTALL CONSOLE UPPER PANEL GARNISH NO. 2
4. INSTALL CONSOLE UPPER PANEL GARNISH NO. 1
5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER
6. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
7. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

HINT: Perform yaw rate sensor zero point calibration Programming and Relearning.

8. CHECK SPEED SENSOR SIGNAL

HINT: Check the speed sensor signal Test Mode Procedure.