Removal

BRAKE CONTROL: FRONT SPEED SENSOR: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The following procedures is for the LH side.
- If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.
for 2GR-FE Removal
for 2GR-FE Disassembly
for 1AR-FE Removal
for 1AR-FE Disassembly

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

2. REMOVE FRONT WHEEL
3. REMOVE NO. 1 ENGINE UNDER COVER Removal
4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH Removal
5. REMOVE FRONT WHEEL OPENING EXTENSION PAD Removal
6. REMOVE FRONT FENDER LINER Removal
7. REMOVE FRONT SPEED SENSOR





(a) Disconnect the front speed sensor connector and remove the 2 clamps.





(b) Remove the bolt and No. 2 sensor clamp from the body.





(c) Remove the bolt, No. 1 sensor clamp, and flexible hose together from the shock absorber assembly.





(d) Remove the bolt, resin clamp, and the front speed sensor.

NOTICE :
- Prevent foreign matter from attaching to the front speed sensor tip.
- Clean the installation hole and the contact surface for the front speed sensor every time it is removed.