Installation

1GR-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

INSTALLATION





1. INSTALL E.F.I. ENGINE COOLANT TEMPERATURE SENSOR
(a) Using a 19 mm deep socket wrench, install the water temperature sensor with a new gasket.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(b) Connect the connector.
2. CONNECT FUEL PIPE SUB-ASSEMBLY NO.2 Installation
3. INSTALL INTAKE AIR SURGE TANK Installation
4. INSTALL AIR CLEANER ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
6. ADD ENGINE COOLANT Service and Repair
7. CHECK FOR FUEL LEAKAGE
8. CHECK FOR ENGINE COOLANT LEAKAGE Service and Repair
9. INSTALL V-BANK COVER Installation