Installation

2GR-FXE ENGINE CONTROL SYSTEM: CAMSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CAMSHAFT POSITION SENSOR (for Bank 1)

(a) Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.

(b) Install the camshaft position sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the camshaft position sensor connector.

2. INSTALL CAMSHAFT POSITION SENSOR (for Bank 2)

(a) Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.

(b) Install the camshaft position sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the camshaft position sensor connector.

3. INSTALL EGR DELIVERY CHAMBER

Installation