Removal

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.

2. REMOVE DECK BOARD ASSEMBLY Removal

3. REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE COOL AIR INTAKE DUCT SEAL Removal

6. REMOVE RADIATOR GRILLE Removal

7. REMOVE FRONT BUMPER ASSEMBLY Removal

8. REMOVE HEADLIGHT ASSEMBLY Removal

9. REMOVE FRONT AIRBAG SENSOR

(a) Disconnect the connector from the front airbag sensor.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the 2 bolts.

NOTICE:
Loosen the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.

(c) Disengage the 2 claws and pin, and remove the front airbag sensor from the body.